"Final" updates to my SSS #002 eyelet layout. I've shuffled components around slightly to accommodate 5w wirewound resistors on v2 and v3, as well as optimized the reverb layout with the 2.2k resistor change. I've also updated the component type to reflect the real amp BUT I still support my initial build's use of metal film on cathodes and ground points to lower the noise floor as far down as we can. Trying to appease the purists out there that want as close to 1:1.
I've also updated each board individually so you can print the PDF out 1:1 and drill your own boards if you'd like (or upload to Hoffman's site). Attaching both metal film and 1:1 component selection on the signal boards. Enjoy!